In this video i’m showing you how to assemble and paint a lure i designed.
you can find the free files here: https://www.thingiverse.com/thing:5761972
All painting was done with cheap spraycans.
All you need;
-0,8mm stainless steel spring wire
-5mm fish eyes
-5 and 3 mm nails
-fine mesh and tape ( for painting)
-White primer
-Aluminum metallic paint
-Anthracite/ dark gray paint
-Red
-Clear coat (high gloss)
Please leave a comment about what you think of the video,
Thanks for watching.
song:
Joyride by tubebackr & Sarah Jansen
https://soundcloud.com/tubebackr
https://soundcloud.com/sarahjansenmusic
Creative Commons — Attribution 3.0 Unported — CC BY 3.0
Free Download / Stream: https://bit.ly/3p6ATNa
Music promoted by Audio Library https://youtu.be/4WEhrLE9BWg
Free files can be downloaded here: https://www.thingiverse.com/thing:5761972
Really good job on the lures and explaining how to. Im going to try the lure but will be using a fdm printer should be interesting. How does the resin hold up?
I have a question. Are you sure it would hold the fish, since the line wouldn't be attached directly to the hook? I mean it's all glued together, but would it withstand a big fish?
Are the files free ? Or do you sell ?
Awesome looking design! Any fish catches yet??
I wanted to get into glidebaits and after seeing how expensive they were I searched for how to 3D print them and your content came up. I’m thankful I came across your channel! I’ll definitely be going this route thanks to how well you shot and explained everything!